|
After the litespeed was rebuilt recently, i started getting random 503 errors (not always as old situation) -- even with less traffic.
even though memory soft & hard limit have been set to 1024mb.
APC settings are still the same, at least :
- shm_size is 512mb
- ttl is 0
- stat is 0
Probably some other old litespeed settings were gone?
Is there any other settings other than memory soft & hard limit that i should check?
__________________
I use litespeed
Last edited by semprot; 04-26-2012 at 01:43 PM..
|