Differences
This shows you the differences between two versions of the page.
— |
litespeed_wiki:cache:litemage:troubleshooting:checking-hole-punching [2016/05/06 14:02] (current) Michael Alegre created |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== How to check if ESI block holes are being properly punched ====== | ||
+ | From LiteMage Extension 1.0.2 onward, you can display holes punched during the ESI process by adding the GET parameter "LITEMAGE_DEBUG=SHOWHOLES". This is useful for checking if all private blocks are being properly hole punched by LiteMage. | ||
+ | |||
+ | To do this, navigate to System > Configuration > LITEMAGE CACHE > LiteMage Configuration and either set **Enable Debug** to "Yes" in the "Developer Testing" section under , add your IP address to the list in **Enable LiteMage Cache Only for Listed IPs** in the same section, or add your IP address to the list in **Admin IPs** under the "General Settings" section. | ||
+ | |||
+ | You Should now be able to append "?LITEMAGE_DEBUG=SHOWHOLES" to the end of any LiteMage enabled URL and the injected blocks on the page will now be highlighted except for valueOnly blocks. | ||
+ | |||
+ | For example: | ||
+ | {{:litespeed_wiki:cache:lmshowholes.png?direct 800px|}} | ||
+ | |||
+ | **Note:** If used, it is recommended to set **Enable Debug** back to "No" when finished. |