Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
litespeed_wiki:cache:lscxf:installation [2016/09/30 21:29]
Rob Holda [Testing]
litespeed_wiki:cache:lscxf:installation [2019/05/17 14:37] (current)
Kacey Schroeder [Pre-Installation Requirements]
Line 5: Line 5:
  
   * LiteSpeed Web Server Enterprise Edition 5.0.12+.   * LiteSpeed Web Server Enterprise Edition 5.0.12+.
-  * LSCache Module. (Included with a 2-CPU or higher ​license. Can be purchased as an add-on for VPS, Ultra VPS, and 1-CPU licenses.)+  * LSCache Module. (Included with all current licenses as well as the 8-CPU legacy ​license. Can be purchased as an add-on for VPS, Ultra VPS, and 1-CPU legacy ​licenses.)
  
 ===== LiteSpeed Web Server Settings ===== ===== LiteSpeed Web Server Settings =====
Line 68: Line 68:
 ===== XenForo Debug Mode ===== ===== XenForo Debug Mode =====
  
-To enable debug mode in XenForo , add the following to "​config.php"​ under XenForo'​s "​library"​ directory:+To enable debug mode in XenForo, add the following ​lines to your "​config.php" ​file under XenForo'​s "​library"​ directory:
  
-<​code>​$config['​debug'​] = true;</​code>​ \\ **Note:​** ​It is not recommended ​to enable debug mode on a production site as it will increase resource utilization.+<​code>​$config['​debug'​] = true;</​code>​ \\ **Note:​** ​Enabling debug mode is not recommended on a production site as it will increase resource utilization.
  
 If you would like to enable debug mode only for certain IPs, you can instead add the following: If you would like to enable debug mode only for certain IPs, you can instead add the following:
Line 76: Line 76:
 <​code>​if($_SERVER['​REMOTE_ADDR'​] == '​127.0.0.1'​){$config['​debug'​] = true;​}</​code>​ <​code>​if($_SERVER['​REMOTE_ADDR'​] == '​127.0.0.1'​){$config['​debug'​] = true;​}</​code>​
  
-Where you can replace ​127.0.0.1 with the desired IP Address.+Replacing ​127.0.0.1 with the desired IP Address.
  • Admin
  • Last modified: 2016/09/30 21:29
  • by Rob Holda