Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
litespeed_wiki:config:enable_quic:apache_configuration_with_direct_admin [2017/08/16 20:17] Johathan Kagan |
litespeed_wiki:config:enable_quic:apache_configuration_with_direct_admin [2017/08/23 20:05] (current) Jackson Zhang |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== How to enable QUIC through Apache configuration with Direct Admin ===== | ====== How to enable QUIC through Apache configuration with Direct Admin ===== | ||
| - | If LSWS is reading your Apache configuration through Direct Admin you can use the a directive in that file to turn QUIC on or off at the server or vhost level. Add the following directive to the Apache configuration file. | ||
| - | <IfModule LiteSpeed> | + | To enable QUIC, there is no configuration change in LSWS. For control panel, QUIC is turned on by default for Apache HTTPS vhosts. |
| - | QuicEnable on|off | + | |
| - | </IfModule> | + | |
| - | When you set QuicEnable at the Apache server level, all vhosts will use that setting as their default. Vhosts level can not rewrite server level.\\ | + | All user need to do is open UDP port 443. |
| - | Please bear in mind that QUIC can only be used for HTTPS vhosts. | + | |
| - | ==== Requirements ==== | + | HTTPS with trusted cert, |
| + | UDP port 443 open at the firewall. | ||
| + | |||
| + | The followings explain the directives could be possibly used but may not necessary at the initial stage. | ||
| + | |||
| + | |||
| + | ====== Directive examples ===== | ||
| + | ===== Requirements ===== | ||
| * Must have QUIC enabled in GUI/conf | * Must have QUIC enabled in GUI/conf | ||
| * Must use either Chrome or Opera with QUIC enabled | * Must use either Chrome or Opera with QUIC enabled | ||
| Line 17: | Line 20: | ||
| * QUIC will only apply to https, not http | * QUIC will only apply to https, not http | ||
| * QUIC can be enabled at the server level, listener level or virtual host level | * QUIC can be enabled at the server level, listener level or virtual host level | ||
| + | |||
| + | ===== Configuration ===== | ||
| + | If LSWS is reading your Apache configuration through Direct Admin you can use the a directive in that file to turn QUIC on or off at the server or vhost level. Add the following directive to the Apache configuration file. | ||
| + | |||
| + | <IfModule LiteSpeed> | ||
| + | QuicEnable on|off | ||
| + | </IfModule> | ||
| + | |||
| + | When you set QuicEnable at the Apache server level, all vhosts will use that setting as their default. Vhosts level can not rewrite server level.\\ | ||
| + | Please bear in mind that QUIC can only be used for HTTPS vhosts. | ||
| + | |||