Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
litespeed_wiki:config:enable_quic [2019/03/26 18:14] Jackson Zhang [LF_SPI needs to be turned off when CSF used] |
litespeed_wiki:config:enable_quic [2019/07/18 12:49] Eric Leu [cPanel] |
||
|---|---|---|---|
| Line 27: | Line 27: | ||
| If there is no extra firewall such as CSF, UDP 443 should be enabled by default. If CSF is used, you need to enable it at the CSF level. | If there is no extra firewall such as CSF, UDP 443 should be enabled by default. If CSF is used, you need to enable it at the CSF level. | ||
| + | ConfigServer Security & Firewall -> csf - ConfigServer Firewall -> Firewall Configuration -> IPv4 Port Settings -> UDP_IN and UDP_OUT should enable ''443''. | ||
| + | |||
| {{ :litespeed_wiki:config:udp-443-csf-quic.png?400 |}} | {{ :litespeed_wiki:config:udp-443-csf-quic.png?400 |}} | ||
| - | Also make sure that ''UDPFLOOD'' is set to 0. | + | Also make sure that ''UDPFLOOD'' is set to Off ''0''. |
| + | |||
| ==== Plesk ==== | ==== Plesk ==== | ||
| If a firewall is activated, you need to enable UDP 443 manually. | If a firewall is activated, you need to enable UDP 443 manually. | ||