Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
litespeed_wiki:cache:litemage:customization:keeping-public-cache-warm-indefinitely [2016/04/27 18:58] Rob Holda |
litespeed_wiki:cache:litemage:customization:keeping-public-cache-warm-indefinitely [2016/05/11 14:47] Rob Holda removed |
||
|---|---|---|---|
| Line 19: | Line 19: | ||
| **Note:** This can be done on a per-store basis by changing your Current Configuration Scope. | **Note:** This can be done on a per-store basis by changing your Current Configuration Scope. | ||
| - | **Note:** LiteMage will not crawl your site all at once within the set **[[litespeed_wiki:cache:litemage:configuration:cache_warm_up#maximum_run_time_seconds|Max Run Time]]**. This can be caused by a large site or a high server load at run time, where the crawler will stop to prevent it from using up your remaining server resources. In these cases, the crawler should continue where it left off on its next run. This may cause parts of your site to not remain in cache. You can restart a crawlers queue without flushing your cache by clicking the reset link at the bottom of the **System→Cache Management** page in the Magento Admin Panel. | + | **Note:** LiteMage will not crawl your site all at once. In order to prevent the crawler from using all of your server's resources and allow flexibility, the crawler will be run once every 10 minutes (600 seconds). You can set the **[[litespeed_wiki:cache:litemage:configuration:cache_warm_up#maximum_run_time_seconds|Maximum Run Time]]** for a crawler run to any value less than 600 seconds, the default duration being 5 minutes (300 seconds). When the crawler reaches this time limit, it stops until it's next run and then resumes where it left off. If your **Default Public Cache TTL** setting is too low, parts of your site will not remain in cache. |
| - | **Note:** Users can also set their own **[[litespeed_wiki:cache:litemage:configuration:cache_warm_up#custom_defined_url_list|Custom Defined Url list]]** in case they wish to refresh certain URLs more or less frequently than their crawler queues. | + | **Note:** You can restart a crawlers queue without flushing your cache by clicking the reset link at the bottom of the **System→Cache Management** page in the Magento Admin Panel. |
| - | **Note:** Refreshing the cache is **[[litespeed_wiki:cache:litemage:administration#litemage_crawler_warm-up_status|not the same]]** as invalidating it. | + | **Note:** Users can also set their own **[[litespeed_wiki:cache:litemage:configuration:cache_warm_up#custom_defined_url_list|Custom Defined Url list]]** in case they wish to refresh certain URLs more or less frequently than their crawler queues. |
| **Note:** If, after updating a page, a user wants to refresh the cached copy of this page, they can use the following command in a cron job to refresh the cached copy programmatically: <code>curl -A "litemage_walker" https://your_url</code> | **Note:** If, after updating a page, a user wants to refresh the cached copy of this page, they can use the following command in a cron job to refresh the cached copy programmatically: <code>curl -A "litemage_walker" https://your_url</code> | ||